Export a sequence to tape without device control – Adobe Premiere Pro CC v.7.xx User Manual
Page 569
Facebook posts are not covered under the terms of Creative Commons.
Note:
Note:
6. Click Record, or, for HDV devices click Render And Record.
If exporting to an HDV device, a rendering dialog box will open with a progress bar showing the progress of the transcode to HDV. Typically,
export to tape will begin when transcoding is about 50% done.
7. If you don’t need to perform any more recordings after the Recording Successful message appears in the Status option, click Cancel to close
the Export To Tape dialog box.
If you want to use device control but it’s unavailable, click Cancel. Choose Edit > Preferences, click Device Control, make sure that
your device is set up properly in the Device Control options, and click OK. Then try recording to tape again.
Export a sequence to tape without device control
You can export to videotape without device control by operating the playback controls in Premiere Pro and the recording controls on the device
itself.
You can export to tape on an HDV device in Windows only, and only with device control.
1. Activate the sequence you want to export.
2. Make sure that the sequence plays back on your deck or camera. If it does not, review the steps for preparing for exporting to tape (See
Prepare for exporting to DV videotape
), or see the documentation for your analog device.
3. Make sure that the video recording device is in Record-Pause mode, and that the tape is cued to the point where you want to start
recording.
4. Position the current-time indicator at the beginning of the sequence (or work area, as needed).
5. Press the Record or Pause button on the device, as needed to put the device into Record mode.
6. Press the Play button in the Program Monitor.
7. When the program finishes, press the Stop button in the Program Monitor, and then press Stop on the device.
Adobe also recommends
572