EXFO FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/500/IQS-600 User Manual
Page 76
Selecting and Starting a Test
64
FTB/IQS-88000 Series
Ethernet Test Applications
3d. Tap the protocol block
1
to configure the frame structure and its
parameters (refer to page 70). For RFC 2544 in Dual Port topology,
there is a protocol block for each port.
3e. Tap the test block
2
to configure the specific test settings (refer to
page 70).
3f. Tap the clock block
3
to configure the clock synchronization (refer
4. Tap the Timer tab to automatically start and/or stop the test at a given
time or for a specific duration (refer to Timer on page 241).
5. For additional test configurations refer to Test Functions on page 407.
6. Tap the Start button from the right navigation bar to start the test (refer
to Start/Stop|TX Button on page 520). The Summary result page will
be automatically displayed when the test is started from any Setup
configuration page. For additional results refer to Test Results on
page 249.
7. Depending on the test, when the test ends automatically or manually
stopped, the generate report pop-up is displayed by default. If required,
tap Yes to generate a report of the test results and statistics (refer to
Report Button on page 509 for more information).
1. Not available with Smart Loopback, Through Mode, TCP Throughput, Carrier Ethernet OAM, and Cable Test.
2. Not available with Traffic Gen & Mon and Through Mode.
3. Not available in Dual Port topology. However the clock is set to Internal.