EXFO FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/500/IQS-600 - Manual (Page 202)

Test Setup - Test Configurator, Timer, and System
190 FTB/IQS-88000 Series
Services - Global

Direction, available with Dual Test Set or Dual Port topology,
indicates respectively results from local to remote (L -> R) and remote
to local (R -> L), or P1 to P2 (P1->P2) and P2 to P1 (P2->P1).

Frame Size
1
indicates the frame size of each service. Tap on the Frame
Size button to modify the frame size of each service; not available in
Dual Port topology.

Framing indicates the framing of each service. Tap on the Framing
button to modify the Frame Format, Network Layer, Transport Layer,
VLAN, and MPLS (see Modify Frame Structure from the MAC/IP/UDP
on page 148); not available in Dual Port topology.

VLAN (ID/Priority) indicates the ID and Priority of each VLAN level for
each service. Tap on the VLAN button to modify the VLAN settings (see
VLAN from the MAC/IP/UDP on page 148); not available in Dual Port
topology.

Addressing indicates the source and destination IP addresses for each
services. Tap on the Addressing button to modify the addressing (see
MAC and IP from the MAC/IP/UDP on page 148); not available in Dual
Port topology.
Batch button allows bulk configuration for services addressing. Select
the check box of each configuration parameter that needs to be copied
and set its parameters. From Apply To, select all services the copy
applies to and tap on the Copy From to proceed.
SLA Button
The SLA parameters are displayed and configurable per service. Click on
the desired column button to access the configuration settings.
See General Button on page 189 for more information on check boxes,
Direction, and Service Name.
See SLA Parameters on page 197 for more information on CIR, CIR+EIR,
CBS, EBS, Max Jitter, Max Latency, and Frame Loss.