EXFO FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/500/IQS-600 - Manual (Page 195)

Test Setup - Test Configurator, Timer, and System
Power Blazer 183
S-OAM and MPLS-TP OAM

MEG Level (Y.1731, MEF, and G.8113.1) is the Maintenance Entity
Group Level configurable from 0 to 7 (default).

MD Level (802.1ag) is the Maintenance Domain Level and is
configurable from 0 to 7 (default).

MEP ID is the Maintenance Entity Group End Point Identification
configurable from 0x0001 (default) to 0x1FFF.
Peer MEP Parameters

MAC Address
1
allows to enter the unique Media Access Control (MAC)
address of the peer MEP (default is 00:00:00:00:00:00).

MEP ID is the Maintenance Entity Group End Point Identification
configurable from 0x0001 (default) to 0x1FFF.

OAM Quick Ping verifies the bidirectional connectivity with the peer
MEP. The Successful message is reported when at least one of three
attempts has been successful otherwise Failed is reported.
Continuity Check

CC Function check box when selected (default) allows to transmit and
monitor CCM frames.
The following parameters are only configurable when the CC Function
check box is cleared.

Address Type
1
defines the destination address type of the CCM
frames: Unicast or Multicast (default).

Priority
12
allows to select the VLAN user priority: 0 to 7 (default). Refer
to VLAN ID and Priority on page 624 for more information.
1. Available with S-OAM Mode.
2. Available when VLAN is enabled (see VLAN on page 166).