EXFO FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/500/IQS-600 - Manual (Page 330)

Test Results
318 FTB/IQS-88000 Series
Alarms/Errors

Burst Single
1
available with any SONET/SDH layer, generates a
burst of consecutive alarmed frames and then automatically stops
the transmission. Use the Duration field to set the burst duration.

Burst Repeat
1
available with any SONET/SDH layer, generates a
burst of consecutive alarmed frames over the period continuously.
Use the Duration field to set the burst duration and the Period
field to set the period.

Duration available with Burst Single and Burst Repeat modes, allows
the selection of the burst duration: 1 (default) to 14400000 frames or 1
to 1800 seconds. The burst duration value must be less of equal to the
period value.

Period
For GFP layer, allows to set the alarm period associated with the client
management frames: 10 ms to 1200 ms (default is 100 ms).
For Burst Repeat mode, allows the selection of the burst period: 1
(default) to 14400000 frames or to 1800 seconds. The burst period
value must be bigger or equal to the duration value.

User-Defined UPI available with GFP layer, allows entering the Client
Management Frame UPI value when GFP-User-Defined CMF alarm is
selected.
1. Available with OC-768/STM-256 interface only.
UPI Description for PTI = 100
0000 0000 and 1111 1111 Reserved
0000 0001 Client Signal Fail (Loss of Client Signal)
0000 0010 Client Signal Fail (Loss of Client Character
Synchronization)
0000 0011 through 1111 1110 Reserved for future use