EXFO FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/500/IQS-600 - Manual (Page 33)

Physical Interfaces and LEDs
Power Blazer 21
Fibre Cables Connection
Fibre Cables Connection
Carefully connect optical fibre cables to the CFP/CFP2/XFP/SFP/SFP+’s IN
and OUT ports. To ensure good signal quality, make sure that the optical
fibre connector is fully inserted into the optical connector port.
EXT CLK
The FTB/IQS-88000 Series provides one connector, labeled EXT CLK that
can be used either for input/output external clock DS1 (1.5M), E1 (2M),
2MHz, or 1PPS synchronization signal. 1PPS is available for Dual Test Set in
One-Way Latency measurement mode. The connector type is SMB for
coaxial 75-ohm cable connection. An adapter cable (SMB to Bantam) is
required for Bantam connection (not supplied).
REF OUT
The FTB/IQS-88000 Series provides a connector, labelled REF OUT, for eye
diagram clock signal generation that can be used by another equipment.
The clock connector type is SMA.
LEDs

LASER red LED is on when the FTB/IQS-88000 Series is emitting an
optical laser signal.

LINK/RX and LINK green LED is on when the link is up, off when the
link is down, and flashing when frames are transmitted and/or
received.

The blue LED is on when this port corresponds to the interface
selected for the test.
C
AUTION
To prevent exceeding the maximum input power level please use an
attenuator when a loopback configuration is used.