EXFO FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/500/IQS-600 - Manual (Page 208)

Test Setup - Test Configurator, Timer, and System
196 FTB/IQS-88000 Series
Services - Profile
Test Parameters
Note: Unit selection is available from the SLA Parameters on page 197.
For Dual Test Set, parameters are configurable for both local to remote
(L -> R) and remote to local (R -> L) directions.
For Dual Port topology, parameters are configurable for both P1 to P2
(P1->P2) and P2 to P1 (P2->P1)

Traffic Policing check box when selected (default) allows to stress the
rate limiting of the network by sending traffic at higher rate than
committed by the SLA.

Burst Max Rate allows to set the rate that is used for the CBS and EBS
burst tests. Only available when the Burst Test is enabled (see
EtherSAM - Global on page 124).
Note: Changing a criteria value (CIR, CIR+EIR, Ramp Traffic Policing, or Burst
Max Rate) may affect the other criteria values in order to comply to the
following rules:
CIR  CIR+EIR  Ramp Traffic Policing Rate  Line Rate
CIR  CIR+EIR  Burst Max Rate  Line Rate
However, make sure that the criteria values comply to the following rule
with an adequate margin, as per ITU-T Y.1564 standard, for a burst test to
be valid:
CIR  CIR+EIR  Burst Max Rate  Line Rate