EXFO FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/500/IQS-600 - Manual (Page 192)

Test Setup - Test Configurator, Timer, and System
180 FTB/IQS-88000 Series
S-OAM and MPLS-TP OAM
S-OAM and MPLS-TP OAM Responder
S-OAM Responder or MPLS-TP OAM check box when selected (default)
allows to respond to LBM, LTM
1
, DMM, LMM, and SLM
1
valid messages
(test running or not). Traffic statistics are also monitored (refer to
Responder on page 405).
For S-OAM: A valid message must have its source MAC address matching
the Peer MEP MAC address, destination MAC address matching either the
unit port Unicast MAC address or a Multicast class 1 address
2
, VLANs
matching the unit port VLANs, and MEG/MD Level matching the local
MEG/MD Level.
For MPLS-TP OAM: A valid message must have its: destination MAC address
matching either the unit MAC address, FF:FF:FF:FF:FF:FF, or
01:00:5E:90:00:00; VLANs matching the unit port VLANs; MPL Labels
matching the local MPLS Label Stack configuration, including GAL; MEG
Level matches the local MEG Level. For the Loopback function, a valid
message must also have its: MEP ID of the target MEP ID TLV matching the
Local MEP ID or ID Sub-Type is 0x00 (Discovery); and MEP ID and MEG ID
of the requesting MEP ID TVL, if present, matching respectively the Peer
MEP ID and the Local MEG ID.
1. Only available with Ethernet OAM.
2. Refer to Unicast/Multicast Addresses for Ethernet OAM on page 623 for more information.
Respond to... message Respond with... message
LBM LBR
LTM 1 LTR
DMM DMR
LMM LMR
SLM 1 SLR