EXFO FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/500/IQS-600 - Manual (Page 32)

Physical Interfaces and LEDs
20 FTB/IQS-88000 Series
BNC (PORT #1 on FTB/IQS-8805)
BNC (PORT #1 on FTB/IQS-8805)
This port can be used for electrical Transport test applications.
Supported electrical signal are E1/2M, E3/34M, DS3/45M,
STS-1e/STM-0e/52M, E4/140M, and STS-3e/STM-1e/155M. Plug the signal to
be tested to the BNC IN and OUT ports. Connector type is BNC for coaxial
75-ohm cable connection.
AUX (PORT #2 on FTB/IQS-8805)
This port can be used for electrical DS1/DS3 dual RX Transport test
application or for clock synchronization.
DS1/DS3 dual RX: Supported electrical signal are DS1 or DS3 for Dual RX
testing capability. Plug the signal to be tested to the BNC port. Connector
type is BNC for coaxial 75-ohm cable connection.
Clock synchronization: Supported electrical synchronization signals are
DS1 (1.5M), E1 (2M), or 2MHz. Connector type is BNC for coaxial 75-ohm
cable connection. An adapter cable (BNC to Bantam) is required for
Bantam connection (not supplied).
RJ48C (PORT #1 on FTB/IQS-8805)
This port can be used for electrical Transport test applications.
Supported electrical signal are DS1/1.5M and E1/2M. Plug the signal to be
tested to RJ48C port.
BANTAM (PORT #1 on FTB/IQS-8805)
This port can be used for electrical Transport test application.
Supported signal are DS1/1.5M and E1/2M. Plug the signal to be tested to
the BANTAM IN and OUT ports.