EXFO FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/500/IQS-600 - Manual (Page 189)

Test Setup - Test Configurator, Timer, and System
Power Blazer 177
RFC 2544 - Subtests
Thresholds Button
Note: For Dual Test Set, thresholds are configurable for Local to Remote and
Remote to Local directions at the exception of Round-Trip Latency
Threshold for which the value is unique. For Dual Port topology, thresholds
are configurable for P1 to P2 (P1->P2) and P2 to P1 (P2->P1) directions.

Throughput Threshold sets the threshold
1
value used to declare a
pass/fail verdict and it applies to all frame sizes when applicable. The
range is as follows:

Back-to-Back Threshold sets the threshold
1
value in percentage of
frames per burst to declare a pass/fail verdict. The range is from 0.0 to
100.0% (default) and it applies to all frames sizes when applicable.
1. The verdict is PASS when the received/measured value is greater or equal to the threshold value.
Interface
Speed
Max. Rate
% Mbit/s Gbit/s
10 Mbit/s 0.000 to 100.000 a
a. Defalut value.
0.000 - 10.000 a Not Applicable
100 Mbit/s 0.000 to 100.000
a
0.000 - 100.000
a
Not Applicable
1000 Mbit/s 0.000 to 100.000 a 0.000 - 1000.000 a 0.000 - 1.000 a
10G LAN 0.000 to 100.000 a 0.000 - 10000.000 a 0.000 - 10.000 a
10G WAN b
b. The maximum value for 10G WAN may be lower depending on the frame size. The
maximum value will be adjusted for each frame size.
0.000 to 92.8571 a 0.000 - 9230.769 a 0.000 - 9.230 a
40G 0.000 to 100.000 c
c. Default value.
0.000 - 40000.000 c 0.000 - 40.000 c
100G 0.000 to 100.000 c 0.000 - 100000.000 c 0.000 - 100.000 c