EXFO FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/500/IQS-600 - Manual (Page 101)

Test Setup - Test Configurator, Timer, and System
Power Blazer 89
Modify Structure Button
For Ethernet Test Applications

Port 1 and Port 2 are only displayed when Dual Port topology is
selected and allows to configure each port individually.

Interface/Rate choices depend on the selected test and the rates
available on the module. Only rates up to 10G LAN are supported with
Dual Port topology.

Primary Port / Secondary Port, available with Through Mode test
application, allows to select the module’s ports that are respectively
used as primary (Port 1) and secondary (Port 2) port. The configuration
of the network configuration parameters will be available on the
Primary Port only.
Test Interface/Rate
RFC 2544
EtherBERT
Traffic Gen & Mon
Smart Loopback
EtherSAM
100GE (10 Lanes) [103.125Gbit/s]
100GE (4 Lanes) [103.125 Gbit/s]
40GE (4 Lanes) [41.25 Gbit/s]
10GE WAN
10GE LAN
1GE Optical
100M Optical
10/100/1000M Electrical
Carrier Ethernet OAM 10GE WAN
10GE LAN
1GE Optical
100M Optical
10/100/1000M Electrical
Through Mode 1GE Optical
100M Optical
TCP Throughput 1GE Optical
100M Optical
10/100/1000M Electrical
Cable Test 10/100/1000M Electrical