EXFO FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/500/IQS-600 - Manual (Page 360)

Test Results
348 FTB/IQS-88000 Series
S-OAM and MPLS-TP OAM

Invalid Payload indicates the count of received LBR frames having
either a TLV type different than the one transmitted, Bit error or wrong
data value detected in the data payload of a Data TLV, Bit error, Pattern
Loss, or Pattern Type mismatch of a Test TLV, or CRC32 error.

Successful indicates the count of received LBR frames having no
errors.

Failed indicates the count of LBR frames declared as invalid.
Test

Status displays the status of the test function (refer to page 386).

TX TST indicates the count of transmitted TST frames.

RX TST indicates the count of valid TST frames received. A valid frame
for S-OAM has its source MAC address matching the Peer MEP MAC
address; destination MAC address matching either the unit port Unicast
MAC address or a Multicast class 1 address
1
; and VLANs matching the
unit port VLANs. A valid frame for MPLS-TP OAM has its destination
MAC address matching either the unit MAC address, FF:FF:FF:FF:FF:FF,
or 01:00:5E:90:00:00; VLANs matching the unit port VLANs; and MPLS
Labels matching the local MPLS Label Stack configuration.

Invalid TST indicates the count of TST frames received from the peer
MEP with incorrect MEG/MD level.

Invalid Payload indicates the count of received TST frames having
either an unsupported pattern type, or bit error / pattern loss detected
in the payload.

Successful indicates the count of received TST frames having no
errors.

Failed indicates the count of TST frames declared as invalid.
1. Refer to Unicast/Multicast Addresses for Ethernet OAM on page 623 for more information.