EXFO FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/500/IQS-600 - Manual (Page 31)

Physical Interfaces and LEDs
Power Blazer 19
XFP
XFP
XFP PORT #1 can be used for the following test application and optical
rates:
Plug the XFP module into the XFP PORT #1 slot on the module.
Note: Use only EXFO supported transceivers. Refer to the XFP 10GigE Optical
Interface on page 538 for the list of supported transceivers. Using
non-supported transceivers can affect the performance and accuracy of the
test.
Note: Do not replace a XFP while the test is running to avoid distorting statistics.
First stop the test case, replace the XFP and then restart the test.
RJ45
This port can be used for electrical Ethernet, or Packet Sync test
applications.
Supported electrical rates are 10Mbits/s, 100Mbit/s, and 1000Mbit/s.
10Mbits/s is not supported for SyncE. Plug the 10/100/1000 electrical
interface or the cable to be tested to the RJ45 PORT #1 connector on the
module. The electrical ports is RJ45 for category 5 unshielded twisted pair
(UTP). Refer to Ethernet Cables on page 578 for cable specifications.
Application Rates
Transport OC-192/STM-64, OTU2, OTU1e, OTU2e, OTU1f, OTU2f
Ethernet 10Gbit/s LAN, 10Gbit/s WAN
Packet Sync 10Gbit/s LAN
Fibre Channel 10X