EXFO FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/500/IQS-600 - Manual (Page 215)

Test Setup - Test Configurator, Timer, and System
Power Blazer 203
Signal (Transport)
TX Frequency
Note: The following TX Frequency information applies to serial interface only,
refer to TX Frequency on page 133 for parallel interface. Frequency offset is
not available when Through mode is selected.

TX Frequency (GHz) indicates the frequency (actual frequency +
Frequency offset) used for transmission.

Offset (ppm) check box, when selected (cleared by default), allows to
set the frequency offset that will be generated. Use the “+” or “-”
button to respectively increment or decrement the frequency offset
value based on the defined Increment/Decrement Size, or directly
type the frequency offset value in the field. Possible offsets are:
Interface Frequency Offset a Nominal Frequency
DS1 ±140 ppm 1544000 bit/s
E1 ± 70 ppm 2048000 bit/s
E3 ± 50 ppm 34368000 bit/s
DS3 44736000 bit/s
STS-1e/STM-0e 51840000 bit/s
E4 139264000 bit/s
STS-3e/STM-1e 155520000 bit/s
OC-1/STM-0 ± 50 ppm 51840000 bit/s
OC-3/STM-1 155520000 bit/s
OC-12/STM-4 622080000 bit/s
OC-48/STM-16 2488320000 bit/s
OC-192/STM-64 9953280000 bit/s
OTU1 ± 50 ppm 2666057143 bit/s
OTU2 ± 50 ppm (Framed)
± 120 ppm (Unframed) 10709225316 bit/s
OTU1e ± 120 ppm 11049107143 bit/s
OTU2e 11095727848 bit/s
OTU1f 11270089286 bit/s
OTU2f 11317642405 bit/s