EXFO FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/500/IQS-600 - Manual (Page 198)

Test Setup - Test Configurator, Timer, and System
186 FTB/IQS-88000 Series
S-OAM and MPLS-TP OAM

Continuous check box when selected (default) specifies that the
frame generation is continuous. The Continuous check box is cleared
for Multicast address type.

Requesting MEP ID TLV (G.8113.1) check box when selected (default)
determines if the Requesting MEP ID TLV is present in the LBM frame.
The Requesting MEP ID TLV check box is cleared and not selectable
when the Continuous check box is selected.

Priority
12
allows to select the VLAN user priority: 0 (default) to 7. Refer
to VLAN ID and Priority on page 624 for more information.

Drop Eligible
12
, when set to Yes (DEI = 1), the transmitted frames will
be dropped first on receipt when congestion occurs under test. Drop
Eligible is only configurable with Unicast address type, otherwise is set
to No (Default). Drop Eligible is set to No for Frame Delay, Frame Loss,
and Synthetic Loss functions.

Period determines the transmission period of frames which is set to
100 ms. Period is not applicable for Multicast address type or when the
Continuous check box is selected.

TX Rate (%) is the transmission rate of the LBM frame: 0.0001 to 95%
for 10M, 99.5% for 100M, 99.95% for 1G, 99.995% for 10G LAN, and
92.8521% for 10G WAN. Only available with Loopback test function
when the Continuous check box is selected.
1. Available with S-OAM Mode.
2. Available when VLAN is enabled.(see VLAN on page 166)