EXFO FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/500/IQS-600 - Manual (Page 158)

Test Setup - Test Configurator, Timer, and System
146 FTB/IQS-88000 Series
Labels
Labels
For SONET/SDH BERT, from the Test menu, tap Setup, Test Configurator,
the interface block, and on the Labels tab.
For OTN-SONET/SDH BERT, from the Test menu, tap Setup, Test
Configurator, the protocol block, and on the Labels tab.
Note: Selecting a Label byte to be generated will automatically update the
corresponding OH byte. Refer to OH - SONET/SDH on page 458 for more
information.
Labels

STS/AU Path (C2): The C2 byte is allocated to indicate the content of
the STS SPE / VC, including the status of the mapped payloads.
Generated: Select the C2 byte from the list. Selecting a C2 byte value
will automatically update the OH C2 selection and vice versa. Refer to
C2 on page 466 for more information.

PLM-P/UNEQ-P / HP-PLM/HP-UNEQ: Enables the Payload Mismatch
and STS/AU UNEQ monitoring. This setting is coupled with the
configuration of Traces - SONET/SDH on page 398.
Expected: Select the expected C2 byte from the list. Refer to C2 on
page 466 for more information.

VT/TU Path (V5): The V5 byte is allocated to indicate the content of the
VT/TU path, including the status of the mapped payloads.

Generated: Select the V5 byte from the list. Selecting a V5 byte value
will automatically update the OH V5 selection and vice versa. Refer to
V5 on page 469 for more information.