EXFO FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/500/IQS-600 - Manual (Page 36)

Graphical User Interface Overview
24 FTB/IQS-88000 Series
Status Bar
Status Bar
The status bar displays the following information.
Icon
and/or text
Description
Test
Application
Test icon Test icon of the test. All
P1, P2 Port number (Port 1 or Port 2) All
TX/RX, TX, RX Indicates the direction of the signal per port. Transport
Interface/
Signal The interface or signal rate per port: 1GE Optical, 40G, OTU1,
OTU2, OTU3, etc. All
LINK Green arrow: Ethernet Link up.
Red arrow: Ethernet Link down. All
PTP Green arrow: Signaling requests granted.
Red arrow: Request denied, session canceled, or no reply.
Gray arrow: Pending or inactive.
Refer to Negotiation Status on page 366 for more information. 1588 PTP
ESMC Green arrow: ESMC valid information frame received.
Red arrow: No ESMC valid information frames received.
Gray arrow: Pending state.
Refer to ESMC Monitoring on page 236 for more information. SyncE
Power Level The received optical signal status:
Green with “Power”: Power level in range
a .
Yellow: Power level out-of-range b .
Red with “LOS”: Loss of signal b .
Red with “Power”: Power level is close to damage.
Gray: The operational range value is either not available or not supplied by
the transceiver.
All except for
Cable Test
Laser ON b . The laser icon is not displayed when the laser is off a . The laser
icon is only displayed for optical interfaces. The laser is ON by default when
the test is created. The laser control is not affected when turning off the
laser by generating a LOS for example. Refer to Laser Button on page 501.
All
The status of the received signal pattern per port:
Green: Pattern is synchronized.
Red: Loss of pattern.
Gray: Test is not running (EtherBERT test or EoOTN client) or the RX Pattern
Analysis check box is cleared. Transport
EtherBERT
Fibre Channel