EXFO FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/500/IQS-600 - Manual (Page 422)

Test Functions
410 FTB/IQS-88000 Series
40/100G Advanced - CFP/CFP2 Control

Module Low Power Mode check box (cleared by default).

Module Reset check box (cleared by default).

Module Power Shutdown check box (cleared by default).
CFP/CFP2 Status Pins
Gives the following CFP’s pin status: Hi Power On, Module Ready, Module
Fault, Module Absent, RX Loss of Signal, and Global Alarm. Refer to the
CFP MSA standard for more information.
CFP/CFP2 MDIO Access Interface

MDIO - Bulk Read

MDIO Start Address allows the selection of the MDIO start address
0x0000 (default) to 0xFFFF.

MDIO End Address allows the selection of the MDIO end address
0x0000 to 0xFFFF; default is 0x00FF.

Bulk Read button reads and displays the data based on the
specified MDIO range (MDIO Start Address to MDIO End Address).
Save to CSV button allows to save the read MDIO’s addresses and
data to a CSV file.
Note: The bulk read size is limited to 1024 addresses.