EXFO FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/500/IQS-600 - Manual (Page 364)

Test Results
352 FTB/IQS-88000 Series
Service Configuration - Burst
Service Configuration - Burst
From the Test menu, tap Results, Service Configuration, and the Burst
tab.
Service Name and Selection
Service Name indicates the name of the selected service.
Select the service to be displayed by either using the left/right arrow or by
tapping over the service numbers area then tapping on a specific service
number. An orange background indicates the selected service while a
green background indicates the services that are enabled.
Committed/Excess

Committed - Burst test is the CBS subtest.

Excess - Burst test is the EBS subtest.

Direction, available with Dual Test Set or Dual Port topology,
indicates respectively results from local to remote (L -> R) and remote
to local (R -> L), or P1 to P2 (P1->P2) and P2 to P1 (P2->P1).

Burst Size indicates the size in bytes of the burst used for each subtest.

SLA Verified indicates the committed SLA parameters that are used to
declare the pass/fail verdict. See Summary (EtherSAM) on page 373 for
more information on Frame Loss, Max Jitter, Round-Trip Latency,
Max Latency, and Max RX Rate.

Informational parameters are for information purpose only, they are
not included in the test pass/fail verdict. See Summary (EtherSAM) on
page 373 for more information on Frame Loss, Max Jitter,
Max Latency, and Round-Trip Latency.

Average RX Rate indicates the measured average utilization
throughput for the CBS subtest.