Echelon OpenLNS - Manual (Page 811)

OpenLNS Programmer's Reference 774
lcaMgmtModePropagateConfigUpdate
s (0).
If the network management mode is set to
lcaMgmtModePropagateConfigUpdate
s (0) when you call the ReplaceEx method,
the network image contained in the
database will be propagated to the new
router and the old router will be
deconfigured, regardless if this option has
been set.
Added to API Prior to LNS Release 3.0.
Reset
Summary Sends a reset command to the router.
Availability Local, full, and lightweight clients.
Syntax object.Reset
Element Description
object The Router object to be reset.
Added to API Prior to LNS Release 3.0.
Test
Summary Tests a router. You must set the router’s Neuron ID before
invoking this method.
You can use this method to verify that a router is able to
communicate on the network, and that a subset of its
configuration matches the information contained in the
OpenLNS database. To pass the test, a router with the
expected Neuron ID must exist on the network, and respond
to queries. If the router is installed, it must contain the
expected domain/subnet/node address, and respond to
subnet/node messages on that address. It must also contain
the expected program ID, and the expected network
management authentication setting (enabled or disabled). If
network management authentication is enabled on the
router, it must contain the correct system authentication key.
Furthermore, the test verifies that there are no other nodes
that respond with the tested nodes subnet/node address.
The results of the test are contained in the Router object's
LastTestInfo property.
This service analyzes the result with the assumption that the
node's network image is up-to-date; therefore, ensure that
the node is up-to-date by invoking this service only while the
MgmtMode property is set to
lcaMgmtModePropagateConfigUpdates (0). This is
because discrepancies between the OpenLNS database and
the current configuration of the router on the network are