Echelon OpenLNS - Manual (Page 673)

OpenLNS Programmer's Reference 636
connection, or via a read
operation .
0 The polling of the monitor point
will continue at the prescribed
interval, even if the value of the
point is received between polling
periods . This is the default.
-1 The value is set to the value
currently stored in the
NvOptions property of the
MonitorSet object. This occurs if
this property is contained in the
NvMonitorOptions object
accessed through the
DefaultOptions or
CurrentOptions property of a
NvMonitorPoint object.
This value is stored in the
ConstLNSMonitorSetOptionDefault
constant.
This may be useful if you want
the value of the property used by
a network variable monitor point
to always match the default
value stored in the MonitorSet
object. This feature, however, is
not available in
server-independent mode.
nvMonOptsObject The NvMonitorOptions object to be
acted on.
Data Type Integer.
Read/Write Read/write.
Added to API LNS Release 3.0.
Retries
Summary Specifies the number of retries to use for acknowledged,
request/response, or repeated service messages. This applies
to network management messages only .
Setting this property through the NvOptions properties of a
permananent monitor set, or through the DefaultOptions
property of a permanent monitor point, does not have an
effect. The default retry count to use for all permanent
network variable and message monitor points is established
by the RetryCount property of the ConnectDescTemplate
specified when the monitor point was created.
You cannot set this property through the DefaultOptions
property of a temporary monitor point because the