Echelon OpenLNS - Manual (Page 473)

OpenLNS Programmer's Reference 436
3 lcaLonMarkObjectRequestSelfTest
Performs a self-test on the object. The
SelfTestResults property of the
LonMarkObject will be updated to reflect
the results of the test.
4
lcaLonMarkObjectRequestUpdateAlarm
Updates the alarm status of the
LonMarkObject . In this case, the
LonMarkAlarm property of the
LonMarkObject will be updated to reflect
the current alarm status of the
LonMarkObject on the network.
5
lcaLonMarkObjectRequestReportMask
Reports the status bit mask of the
LonMarkObject . In this case, the
ReportMask property of the LonMarkObject
will be updated with current information.
6 lcaLonMarkObjectRequestOverride
Overrides the
LonMarkObject .
7 lcaLonMarkObjectRequestEnable
Enables the
LonMarkObject .
8
lcaLonMarkObjectRequestRemoveOve
rride
Cancels an override of the
LonMarkObject ,
without changing the enabled/disabled state
of the LonMarkObject . You can initiate an
override by writing the
lcaLonMarkObjectRequestOverride (6)
value to the Request property. You can
cancel an override, and re-enable the
LonMarkObject , by writing the
lcaLonMarkObjectRequestNormal (0)
value to this property.
9
lcaLonMarkObjectRequestClearStatus
Clears the status of the
LonMarkObject . In
this case, the information contained in the
Status property of the LonMarkObject will
be cleared.
10
lcaLonMarkObjectRequestClearAlarm
Clears the alarm state of the
LonMarkObject . The information contained