Winco DGC-2020 - Manual (Page 96)

Figure 4-22. Engine Crank Settings
A Cranking Style: Cycle or Continuous.
B Number of Crank Cycles: Adjustable from 1 to 7 cycles in 1 cycle increments. Controllers configured for
NFPA compliance have a 1 to 3-cycle range.
C Cycle Crank Time: Adjustable over the range of 5 to 15 seconds in 1 second increments.
D Continuous Crank Time: Adjustable from 5 to 60 seconds in 1 second increments. Controllers
configured for NFPA compliance have a 1 to 45 second range.
E Crank Disconnect Limit: Adjustable from 10 to 100% of nominal engine speed.
F Pre-Crank Delay: Adjustable from 0 to 30 seconds in 1 second increments.
G Pre-Start Contact Configuration: Open After Disconnect or Closed While Running.
H Prestart Rest Configuration: Off During Rest, On During Rest, or Preheat Before Crank.
I Oil Pressure Crank Disconnect Enable: Disable or Enable.
J Crank Disconnect Pressure (psi): Adjustable from 3 to 150 psi in increments of 1 psi.
Automatic Restart
If the DGC-2020 has shut down due to an alarm condition, the automatic restart, when enabled
A , will
automatically clear alarms. An attempt to restart the engine is made after a predetermined time delay B if
the ATS contact input is closed. If an ATS contact is not present, the unit will remain in READY state with
its alarms cleared. A restart will not be attempted if a low fuel alarm or emergency stop is present. The
number of restart attempts
C is programmable. Automatic restart attempts are recorded in the event log.
BESTCOMSPlus automatic restart settings (DGC-2020, System Parameters, Automatic Restart) are
illustrated in Figure 4-23.
Figure 4-23. Automatic Restart Settings
A Auto Restart Enable: Enable or Disable.
B
Auto Restart Interval: Adjustable from 0.5 to 30 minutes in 0.5 minute increments.
C Auto Restart Attempts: Adjustable from 1 to 10 in increments of 1.
4-26 DGC-2020 BESTCOMSPlus Software 9400200990 Rev K