Winco DGC-2020 - Manual (Page 7)

9400200990 Rev K DGC-2020 Introduction v
Firmware Package
Version and Date Change
1.08.01, 01/09  Changed time dial range of 51 element fixed time curve from 0-30 s
to 0-7,200 s.
 Added Phase Toggle Delay setting for front panel HMI.
 Added Off Mode Cooldown feature.
 Added 51-3 element.
 Added Var/PF control.
 Added LSM Input settings.
 Added Checksum Fail and CEM Hardware Mismatch pre-alarms.
 Added kVar A, B, C, and Total metering.
 Added several MTU items to metering.
 Re-arranged
CANbus Setup screens and added ECU Setup screens
on front panel HMI.
 Added support for CEM-2020H.
1.07.02, 09/08  Finalized settings for AEM-2020.
1.06.00, 07/08  Added settings for AEM-2020.
 Added settings for Automatic Generator Detection.
 Added settings for Integrating Reset on 51 function.
 Added settings for Configurable Protection.
1.05.00, 04/08  Added settings for CEM-2020.
1.04.00, 12/07  Added settings for LSM-2020.
1.03.00, 08/07  Added 32 and 40Q protection functions.
 Added Automatic Restart function and Exercise Timer.
 Added dual settings for 51, 27, and 59 functions.
 Added Oil Pressure Crank Disconnect Enable.
 Modified Prestart operation during rest cycle.
 Added 2 additional Engine kW Overload Pre-Alarms.
 Added Low Line Scale Factor for EPS Supplying Load and Engine
kW Overload Pre-Alarms.
 Changed the metering range of coolant temperature to 32-410 F.
 Changed the Low-Coolant Temp Pre-Alarm range to 32-150 F.
1.02.00, 05/07  Added Spanish language support.
1.00.08, 03/07  Minor firmware improvements.
1.00.07, 01/07
 Added Chinese language support.
1.00.06, 11/06
 Initial
release