Winco DGC-2020 - Manual (Page 88)

Figure 4-17. ECU Setup
A ECU Type: Standard, Volvo Penta, MTU MDEC, MTU ADEC, or MTU ECU7.
B Speed Select: Primary or Secondary.
C Accelerator Position: Adjustable from 0 to 100% in 1% increments.
D MDEC Module Type: CAN Module 201, 302, 303, or 304.
E Speed Demand Switch: Analog CAN, Up Down ECU, Up Down CAN, Analog ECU, Frequency, No
CAN Demand.
F Engine RPM: Adjustable from 1,400 to 2,000 in increments of 1.
G Overspeed Test: Off or On.
H Governor Param Switch Over: Off or On.
I Trip Reset: Press to set.
J Int Oil Prime: Press to set.
K Speed Up: Press to set.
L Speed Down: Press to set.
M Speed Demand Limit: Off or On.
N Increased Idle: 0 to 1,000 in increments of 1.
O Engine Start Prime: Off or On.
P Fan Override: Off or On.
Q Mode Switch: Off or On.
R Governor Param Set Select: 0 to 1,000 in increments of 1.
S CAN Rating Switch 1 & 2: Off or On.
T Cylinder Cutout Disable 1 & 2: Off or On.
Modem Setup (Optional)
DGC-2020 controllers with style number xxxxxMxxx are equipped with an internal telephone modem that
has dial-in and dial-out capability. The modem gives the DGC-2020 the ability to dial up to four telephone
numbers
A and annunciate user-selected conditions to specified pagers B . These user-selected conditions
include C :
 27-1 Trip Alarm
 27-2 Trip Alarm
 32 Trip Alarm
 40 Trip Alarm
 47 Trip Alarm
 51-1 Trip Alarm
 51-2 Trip Alarm
 51-3 Trip Alarm
 59-1 Trip Alarm
 59-2 Trip Alarm
4-18 DGC-2020 BESTCOMSPlus Software 9400200990 Rev K