Winco DGC-2020 - Manual (Page 170)

Name Description Symbol
Battery Charger Fail TRUE when the Battery Charger Fail function is
configured as a Pre-Alarm and the activation delay
has expired.
Battery Overvoltage TRUE when the Battery Overvoltage Pre-Alarm
threshold has been exceeded.
Checksum Failure TRUE when some of the user settings or firmware
code has been corrupted. Refer to Section 4,
BESTCOMSPlus Software, Alarm Configuration,
Pre-Alarms, for more details.
Configurable
Protection
Protection 1-8
TRUE when Over 1, Over 2, Under 1, or Under 2 is
configured as a Pre-Alarm and the threshold has
been exceeded. (Over 1 shown.)
Contact Expansion
Module
Multiple Contact
Expansion Modules
Connected
TRUE when more than one CEM-2020 is
connected.
Contact Expansion
Module
Contact Expansion
Module Comm Fail
TRUE when communication from the CEM-2020 to
the DGC-2020 has been lost.
Contact Expansion
Module
Contact Expansion
Modules Hardware
Mismatch
TRUE when the connected CEM-2020 does not
have the same number of outputs as defined on the
System Parameters, Remote Module Setup screen
in BESTCOMSPlus.
Coolant Temp
Sender Fail TRUE when the Coolant Temp Sender Fail is
configured as a Pre-Alarm and the activation delay
has expired.
Diag Trouble Code TRUE when a Diagnostic Trouble Code exists.
ECU Com Loss TRUE when communication to ECU has been lost.
Engine KW Over
Load 1 TRUE when the Engine KW Overload 1 Pre-Alarm
settings have been exceeded.
Engine KW Over
Load 2 TRUE when the Engine KW Overload 2 Pre-Alarm
settings have been exceeded.
Engine KW Over
Load 3 TRUE when the Engine KW Overload 3 Pre-Alarm
settings have been exceeded.
Fuel Leak TRUE when the Fuel Leak Detect function is
configured as a Pre-Alarm and the activation delay
has expired.
Fuel Level Sender
Fail TRUE when the Fuel Level Sender Fail is
configured as a Pre-Alarm and the activation delay
has expired.
Global Pre-Alarm TRUE when one or more Pre-Alarms are set.
5-8 DGC-2020 BESTlogic+ Programmable Logic K 9400200990 Rev