Winco DGC-2020 - Manual (Page 103)

K Max Input Voltage: Adjustable from 0 to 10 V in 1 V increments.
L Alarm Configuration: None, Alarm, Pre-Alarm, or Status Only.
M Threshold: –9999.0 to +9999.0 in increments of 0.1.
N Activation Delay: Adjustable from 0 to 300 s in 1 s increments.
Remote RTD Inputs
An optional AEM-2020 (Analog Expansion Module) provides eight RTD inputs. To make identifying the
RTD inputs easier, a user-assigned name
A can be given to each input.
Select the amount of hysteresis B and RTD type C . A user-adjustable arming delay D disables RTD input
recognition during engine startup. When enabled, an out of range alarm E alerts the user of an open or
damaged RTD input wire.
Each RTD input can be independently configured to annunciate an alarm, pre-alarm, or status only
F when
the RTD input signal falls beyond the threshold G . A user-adjustable activation delay H setting delays alarm
annunciation after the threshold has been exceeded.
A remote RTD input is disabled when Alarm Configuration is set to “None”. Remote RTD input status is
available in BESTlogic+ Programmable Logic when “Status Only” is selected.
BESTCOMSPlus settings for remote RTD inputs (DGC-2020, Programmable Inputs, Remote RTD Inputs)
are illustrated in Figure 4-31. Remote RTD Input #1 is shown.
Figure 4-31. Remote RTD Inputs Settings
A Label Text: An alphanumeric character string with a maximum of 16 characters.
B Hysteresis: Adjustable from 0 to 100 percent in increments of 0.1%.
C RTD Type: 100 Ohm Platinum or 10 Ohm Copper.
D Arming Delay: Adjustable from 0 to 300 s in 1 s increments.
E Out of Range Alarm Type: None, Alarm, Pre-Alarm, or Status Only.
F Alarm Configuration: None, Alarm, Pre-Alarm, or Status Only.
G Threshold: –58 to +482 F in 1F increments or –50 to +250C in 1C increments.
H Activation Delay: Adjustable from 0 to 300 s in 1 s increments.
9400200990 Rev K DGC-2020 BESTCOMSPlus Software 4-33