Winco DGC-2020 - Manual (Page 218)

7-6 DGC-2020 Maintenance and Troubleshooting 9400200990 Rev K
If the speed still does not change when varying the bias:
 Verify that the governor or ECU is equipped and configured to accept bias inputs.
 Check connections to verify the wiring to the governor bias is correct.
 If you have an engine with an ECU, check ECU programming to verify it is set up to
accept a speed bias input.
Engine Speed Decreases When Speed Bias is Increased
Step 1: Navigate to the SETTINGS->MULTIGEN MANAGEMENT->GOV ANALOG OUTPUT screen
and set SPD RESPONSE to DECREASING.
Engine Speed Increases When Speed Bias is Decreased
Step 1: Navigate to the SETTINGS->MULTIGEN MANAGEMENT->GOV ANALOG OUTPUT screen
and set SPD RESPONSE to DECREASING.
Voltage Bias
Generator Voltage Does Not Change When Voltage Bias Changes
Step 1: As a test, you can force a voltage on the AVR bias output by setting the Min Output Voltage
and Max Output Voltage to the same value by navigating to SETTINGS->MULTIGEN
MANAGEMENT->AVR ANALOG OUTPUT. If the bias is current based, you can force a fixed
current by setting the Min Output Current and Max Output Current to the same value by
navigating to SETTINGS->MULTIGENMANAGEMENT->AVR ANALOG OUTPUT.
If the voltage still does not change when varying the bias:
 Verify that the AVR is equipped and configured to accept bias inputs.
 Check connections to verify the wiring to the AVR bias is correct.
 If you have digital voltage regulator, verify it set up and programmed to accept a voltage
bias input.
Generator Voltage Decreases When AVR Speed Bias is Increased
Step 1: Navigate to the SETTINGS->MULTIGEN MANAGEMENT->AVR ANALOG OUTPUT screen
and set VOLT RESPONSE to DECREASING.
Generator Voltage Increases When Speed Bias is Decreased
Step 1: Navigate to the SETTINGS->MULTIGEN MANAGEMENT->AVR ANALOG OUTPUT screen
and set VOLT RESPONSE to DECREASING.