KEYENCE SL-V Series - Manual (Page 92)

3-6 Assembling the Mounting Brackets (SL-VF/VH/VL)
3-16
In
st
allatio
n
to a Mac
h
ine
3
SL-V-M-NO3-E
The thin type mounting bracket must be secured with the three provided screws.
The L-shaped mounting bracket must be secured with three screws as shown below. (Recommended
tightening torque: 0.7 N
· m)
When using the standard mounting bracket or the thin type mounting bracket, the connection cable (unit
connection cable or series connection cable) can be pull out from the rear of the unit. However, this is not
possible when standard mounting bracket A is installed with the opposite direction (1), or when using the
L-shaped mounting bracket (2).
Thin type mounting bracket (OP-51698)
M3
(length: 7 mm)
The SL-V can pivot by loosening this screw
(hexagon socket bolt, width across flat: 2.5
mm). Therefore, this can be used to align the
beam axis. (Recommended tightening torque
of 1 N·m)
L-shaped mounting bracket (OP-42371)
L-shaped mounting bracket
M3 flathead (small head) (length:5mm)
Installation examples of L-shaped mounting bracket
Top view Bottom view
3
2
1
Surface Surface
Surface
Surface
Surface
Surface
NOTE
Good Good No good No good
(1) (2)