KEYENCE SL-V Series - Manual (Page 113)

4-5
Wirin
g
4
SL-V-M-NO4-E
4-4
Examples of Wiring

When using a simple function type cable (PNP output type cable)
• The shielding wire of the PNP output type cable is connected to 0 V line in the SL-V.
Do not connect the shielding wire to +24 V line.
• If there is some open wires (completely disconnected), they will need to be capped.
Automatic reset mode
When using OSSD only
Automatic reset mode
When not using the EDM function
Caution
Cable insulation: Black Cable insulation: Grey
Transmitter Receiv
er
(Inter
loc
k-reset-ready output) Green
(+24 V)
Bro
wn
(+24 V)
Bro
wn
(OSSD2) White (OSSD1) Blac
k
(Reset input)
Y
ello
w
(EDM input) Red
(W
ait input)
Violet
(A
UX output) Red
(0 V)
Blue
(0 V)
Blue
Shield Shield
K2 K1
(Inter
loc
k mode selection input) Pink
Orange/black
(Communication cable 2)
Orange
(Communication cable 1)
K1, K2 :External device (Safety relay unit, etc.)
K1, K2 : External device (Safety relay unit, etc.)
K3
: Solid state contactor
*1
S1 : The switch for wait input (N.O.)
*1
The violet wire needs to be capped it is not used.
(Open circuit : completely disconnected)
S2 : The switch for releasing lockout condition (N.C.)
The yellow wire must be short-circuited to +24 V if
this function is not used.
M : 3-phase motor
PLC : For the monitoring use
*1
*1 These are NON SAFETY-RELATED system.
S1 S2
K3
K2 K1
M
IN OUT
PLC
Cable insulation: Black Cable insulation: Grey
Transmitter Receiv
er
(Inter
loc
k-reset-ready output) Green
(+24 V)
Bro
wn
(+24 V)
Bro
wn
(OSSD2) White (OSSD1) Blac
k
(Reset input)
Y
ello
w
(EDM input) Red
(W
ait input)
Violet
(A
UX output) Red
(0 V)
Blue
(0 V)
Blue
Shield Shield
K2 K1
(Inter
loc
k mode selection input) Pink
Orange/black
(Communication cable 2)
Orange
(Communication cable 1)