KEYENCE XG-8700T - Manual

1
This manual describes the hardware information. Read this manual
thoroughly to understand the performance and functions of the “Multi
Camera High Performance Machine Vision System XG8700T” in order to
maximize the performance of the system.
• Always keep this manual in a safe place for future reference.
• Ensure that the manual is passed to the end user in case of transfer of
the unit.
Trademarks
• “SD Memory Card” is a registered trademark of the SD association.
• Other company names and product names are registered trademarks
or trademarks of their respective companies. The TM mark and ® mark
are omitted in this manual.
Concerning the Library and Program
libjpeg
Copyright ©1991-2010, Thomas G. Lane.
This software is based in part on the work of the Independent JPEG Group.
The equipment and accessories listed below are included in the package
when shipped. Upon opening the carton, check that you have received all
of the equipment and accessories listed below.
Standard Package
• Controller Unit (XG-8700T(P))×1
• SD card (CA-SD1G (1GB))×1
(already installed in the SD card slot (lower)
of the controller)
• Controller instruction manual
(this document)
• Terminal block sticker package x 1
• To connect the controller to a camera, an optional camera input unit (XG-EC80T:
for 3D cameras, CA-EC80LJ/XG-EC80LJ: for the LJ-V, CA-EC80HX/CA-EC80L/
XG-EC80L: for HX Series cameras [when using 16x speed], or CA-EC80/
XG-EC80: for area scan cameras) is required.
• If you are using the CA-EC80HX/CA-EC80L/XG-EC80L: HX Series camera (when
using 16x speed) or the CA-EC80/XG-EC80 (for area scan cameras), see the
XG-8000 Series Setup Manual (Area Scan Camera Edition).
Read this manual thoroughly before using the XG-8700T.
Always keep this manual in a safe place for future reference.
Controller Instruction Manual
Multi Camera High Performance Machine
Vision System
96M13089 Introduction
Package Contents