KEYENCE XG-7000 Series - Manual

1
Super-High-Speed Flexible Image Processor
System
XG-7000 Series
Controller Instruction Manual
Read this manual thoroughly before using the XG-7000 Series.
Always keep this manual in a safe place for future reference.
This manual describes the hardware information. Read this manual
thoroughly to understand how the XG-7000 Series works in order to
maximize the performance of the system.
• This manual covers the XG-7000 Series. All references, unless
otherwise noted, pertain to the XG-7501/XG-7502. For more
details on the differences between the models, see "Main
Specifications" (page 7).
• Always keep this manual in a safe place for future reference.
• Ensure that the manual is passed to the end user in case of
transfer of the unit.
Symbols
The following warning symbols are used to ensure safety and to
prevent human injury and/or damage to property when using the
system.
DANGER
Indicates that the operator is at risk of death or serious physical
injury if the system is improperly operated or this precaution is not
followed.
Warning
Indicates that the operator is at risk of physical injury if the system is
improperly operated or this precaution is not followed.
Caution
Indicates that property could be damaged (product malfunction, etc.)
if the system is improperly operated or this precaution is not
followed.
Indicates important operating procedures that could be easily
overlooked.
Indicates further information that may be useful to know.
Trademarks
• "SD Memory Card" is a registered trademark of the SD
association.
• Other company names and product names are registered
trademarks or trademarks of their respective companies.The TM
mark and ® mark are omitted in this manual.
The equipment and accessories listed below are included in the
package when shipped. Upon opening the carton, check that you
have received all of the equipment and accessories listed below.
Standard Package
• Controller Unit x 1 (XG-7701(P)/
XG-7702(P)/XG-7501(P)/XG-7502(P)/
XG-7001(P)/XG-7002(P)/XG-7001A/
XG-7002A, whichever is appropriate)
• SD card
(other than XG-7701(P)/XG-7702(P):
OP-87133 (512MB), XG-7701(P)/
XG-7702(P): CA-SD1G (1GB)) x 1
(already installed in the SD1 card slot of
the controller)
• Controller instruction manual x 1
• Terminal block sticker package x 1
Introduction
Package Contents
Note
Reference
96M13085