Arc Machines 307 - Manual (Page 127)

Arc Machines, Inc. Model 307 Orbital Tube Welder Training
Document No. 740096 Chapter 11. Page 2.
Rev. A
Pressing WELD on the Weld Schedule-Main screen (previous page) will
bring up the Weld Schedule - Weld Screen. In Test Mode (green Test but-
ton displayed) touching Start initiates a weld sequence without striking an
arc. The rotor will turn at the programmed speed for the programmed
amount of time.
Pressing TEST on the screen above will put the Model 307 into WELD
MODE. Pressing Weld will return the M307 to Test Mode. In WELD MODE
pressing Start on the Weld Screen will start the sequence and the arc.
TO WELD
:
Press Start on the Weld Schedule-Weld Screen in Weld
Mode.
Press START to
begin welding.
Touch
START to
make a
Test run.
Press
Weld to
enter Test
Mode
Touch Test
to enter
Weld
Mode