Brocade Communications Systems RFS6000 - Manual (Page 791)

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 789
53-1001931-01
smart-rf config commands
25
schedule-calibrate
smart-rf config commands
Configures the calibrate schedule parameters
This is used to configure parameters that schedule the automatic configuration of the Smart RF
feature.
Supported in the following platforms:
• Mobility RFS4000 Controller
• Mobility RFS6000 Controller
• Mobility RFS7000 Controller
Syntax
schedule-calibrate [enable |interval |start-time]
schedule-calibrate interval <1-366>
schedule-calibrate start-time <1-31> <1-12>
<2008-2035>
Parameters
Example
RFController(config-wireless-smart-rf)#schedule-calibrate enable
RFController(config-wireless-smart-rf)#schedule-calibrate interval 2
RFController(config-wireless-smart-rf)#schedule-calibrate
start-time 10:30 1 1
RFController(config-wireless-smart-rf)#
enable Enables the schedule-calibrate feature. When enabled, the Smart
RF auto calibration feature is performed at the set interval.
interval <1-366> Sets the interval in days between each auto calibration.
start-time
<1-31> <1-12>
<2008-2035> Sets the time and day to start the first auto-calibration.
is in 24 hours format.