Brocade Communications Systems RFS6000 - Manual (Page 503)

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 501
53-1001931-01
MAC Extended ACL config commands
16
The controller (by default) does not allow layer 2 traffic to pass through the interface. To adopt an
access point through an interface, configure an access control list to allow an ethernet WISP. .v
NOTE
To apply an IP based ACL to an interface, a MAC access list entry to allow ARP is mandatory. A MAC
ACL always takes precedence over IP based ACLs.
The last ACE in the access list is an implicit deny statement. Whenever the interface receives the
packet, its content is checked against all the ACEs in the ACL. It is allowed/denied based on the
ACL’s configuration.
Example - permitting WISP traffic
The example below permits WISP traffic from any source MAC address to any destination MAC
address:
RFController(config-ext-macl)#permit any any type wisp
RFController(config-ext-macl)#
Example - permitting ARP traffic
The example below permits arp based traffic from any source MAC address to any destination MAC
address:
RFController(config-ext-macl)#permit any any type arp
RFController(config-ext-macl)#
Permitting IP traffic
The example below permits IP based traffic from a source MAC address to any destination MAC
address:
RFController(config-ext-macl)#permit host 11:22:33:44:55:66 any type ip
RFController(config-ext-macl)#