Brocade Communications Systems RFS6000 - Manual (Page 619)

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 617
53-1001931-01
Wireless configuration commands
20
convert-ap
Wireless configuration commands
Changes the mode of operation of an AP to either sensor or standalone
Supported in the following platforms:
• Mobility RFS4000 Controller
• Mobility RFS6000 Controller
• Mobility RFS7000 Controller
NOTE
The number of APs supported by
convert-ap
command differs for each controller.
- Mobility RFS7000 Controller supports <1-256> APs
- Mobility RFS6000 Controller supports <1-64> APs
- Mobility RFS4000 Controller supports <1-6> APs
convert-ap [default|sensor|standalone]
convert-ap [default|standalone]
convert-ap sensor {static-ip
{}}
Parameters
Example
RFController(config-wireless)#convert-ap 1 default
Converting an AP to sensor
To convert a BR300 to a sensor:
[default|sensor|
standalone] Sets the indices of the APs to be converted.
•
– The index of the AP to be converted. This index
can be found from the 'show wireless ap' command.
•
default – Does not force conversion. Lets the AP negotiate its
normal mode of operation with the controller.
•
sensor {static-ip {}}– Converts an
BR300 to operate as an IPS (Intrusion Prevention System)
sensor.
•
static-ip – Optional. Sensor must use
specific static IP address.
•
– Sensor IP address and network
mask.
•
– Optional. Specify gateway IP address for
sensors
NOTE: The controller will not be able to adopt this AP again until it
is converted back to a BR300 using the sensor
<1-256> revert-to-ap command
NOTE: The controller will not be able to adopt this AP again until
the AP is converted back to a thin-AP using the AP’s
configuration interface.