Brocade Communications Systems RFS6000 - Manual (Page 662)

660 Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Wireless configuration commands
20
Parameters
Example
RFController(config-wireless)#sensor vlan 268 500
RFController(config-wireless)#
<1-48> [default-config|
requestconfig|
revert-to-ap] Select a sensor to reset/revert the AP to its original state. Use the
show wireless sensor command to view the sensor index.
•
default-config – Restores the internal configuration of the
sensor to default values. This sends the configuration to the
sensor.
•
request-config – Polls the sensor for its latest configuration.
•
revert-to-ap – Reverts an IDS sensor back to an access point
that can service wireless-clients.
default-config [
gateway-ip|ip-mode|
wips-server-ip] Invokes the default configuration sent to sensors when
configured.
•
gateway-ip – Configure the gateway IP address for
sensors to .
•
ip-mode [dhcp|static ] – Configures the IP
address of the sensors.
•
dhcp – Sensors use DHCP to obtain an IP address.
•
static – Sensors use the specific static IP
address.
•
– Sets the sensor IP address and
network mask.
•
wips-server-ip [primary|secondary] – Specifies the IP
addresses of the WIPS server.
•
primary – Specifies the primary IP address of the
WIPS server.
•
secondary – Specifies the secondary IP address of
the WIPS server.
ping-interval <2-60> Sets the ping interval (in seconds) between successive pings to
sensors on the network.
vlan <1-4094> Configures VLANs where sensors are discovered.
•
<1-4094> – Vlan IDs