Brocade Communications Systems RFS6000 - Manual (Page 542)

540 Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Configuring the DHCP server using controller CLI
17
Troubleshooting DHCP Configuration
1. The DHCP Server is disabled by default. Use the following command to enable the DHCP
Server:
RFController(config)#service dhcp
This command administratively enables the DHCP server. If the DHCP configuration is
incomplete, it is possible the DHCP server will be disabled even after the execution of this
command.
2. Use the
network
command to map the network pool to interface.
network 192.168.0.0/24
In the above example, 192.168.0.0/24 represents the L3 interface. When you execute this
command, no check is performed to endorse whether an interface (with the specified
IP/Netmask) exists. The verification is not performed because you can create a pool and map
it to non existing L3 interface.
When you add a L3 interface and assign an IP address to it, the DHCP server gets
enabled/started on this interface. If you have a pool for network 192.168.0.0/24, but the L3
interface is 192.168.0.0/16, DHCP is not enabled on 192.168.0.0/16, since it is different
from 192.168.0.0/24.
3. A network pool without any include range is as good as not having a pool. Add a include range
using the
address range
command.
address range 192.168.0.30 192.168.0.30
4. To work properly, a host pool should have the following 3 items configured:
• client-name (CLI is
client-name
)
• fixed-address CLI is
host
)
• hardware-address/client-identifier
The hardware address is
hardware-address
The client-identifier is
client-identifier
If you use
client-identifier
instead of
hardware-address
, a DHCP client sends the
client-identifier when it requests for IP address. The Client - identifier has to be configured in
the DHCP Client as an ASCII value and the same has to be used in the DHCP server option (for
example, the Client- identifier option).
5. A host pool should have its corresponding network pool configured, otherwise the host pool is
useless. The fixed IP address configured in the host pool must be in the subnet of the
corresponding network pool.
6. If you create a pool and map it to an interface, it automatically gets enabled, provided DHCP is
enabled at a global level. Use the
no network
command to disable DHCP on a per
pool/interface basis.
7. To set a newly created pool as a network pool, use one of the following commands:
• network (for example, network 192.168.0.0/24)
• address range (for example, address range 192.168.0.30 192.168.0.50)
8. To set a newly created pool as a host pool, use one of the following commands:
• host (for example, host 192.168.0.1)