Brocade Communications Systems RFS6000 - Manual (Page 384)

382 Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Crypto Map config commands
10
Usage Guidelines
RFController(config-crypto-map)#set peer name
If no peer IP address is configured, the manual crypto map is not valid and not complete. A peer IP
address is required for manual crypto maps. To change the peer IP address, the no set peer
command must be issued first; then the new peer IP address can be configured.
RFController(config-crypto-map)#set pfs
If left at the default setting, no perfect forward secrecy (PFS) is used during IPSec SA key
generation. If PFS is specified, the specified Diffie-Hellman Group exchange is used for the initial
(and all subsequent) key generations. This means no data linkage between prior keys and future
keys.
RFController(config-crypto-map)#set security-association lifetime
(kilobytes|seconds)
Values can be entered in both kilobytes and seconds. Whichever limit is reached first, ends the
security association.
RFController(config-crypto-map)#set session-key [inbound|outbound]{ah|esp}
RFController(config-crypto-map)#set session-key [inbound|outbound] ah
data>
RFController(config-crypto-map)#set session-key [inbound|outbound] esp
cipher authenticator
The inbound local SPI (security parameter index) must equal the outbound remote SPI. The
outbound local SPI must equal the inbound remote SPI. The key values are the hexadecimal
representations of the keys.
They are not true ASCII strings. Therefore, a key of 3031323334353637 represents “01234567”.
RFController(config-crypto-map)#set transformset name
session-key
[inbound|outbound]
{ah|esp}
<256-4294967295>
cipher Use the set session-key command to define the encryption and
authentication keys for this crypto map
•
inbound [ah|esp] – Defines encryption keys for inbound
traffic
•
outbound [ah|esp] – Defines encryption keys for outbound
traffic
For information on how to create a key for authentication and
encryption, refer Usage Guideline in
Global Configuration
commands under crypto on page 233 .
•
ah <256-4294967295> – Authentication header protocol
•
<256-4294967295> – Security Parameter Index (SPI)
for the security association
•
esp <256-4294967295>– Encapsulating security payload
protocol
•
<256-4294967295> cipher – Defines the security
parameter index
•
cipher – Specify encryption/decryption key
authenticator – Specify an authentication key
transformset Use the set transform-set command to assign a transform-set to a
crypto map