Brocade Communications Systems RFS6000 - Manual (Page 692)

690 Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Wireless configuration commands
20
kdc
[password|realm|server] Modifies KDC related parameters.
•
password [0 |2 |] – Create a KDC
server password (up to 127 characters)
•
0 – Password is specified unencrypted.
•
2 – Password is encrypted with a
password-encryption secret.
•
– Defines a KDC server password (up to 127
characters).
•
realm – Defines a KDC realm (up to 127
characters).
•
– Defines KDC realm (up to 127 characters)
•
server [primary|secondary|timeout] – Modifies KDC server
parameters.
•
primary {auth-port } – Defines the primary
KDC server.
•
secondary {auth-port }– Defines the
secondary KDC server.
•
– Sets the KDC server IP address
•
auth-port – Optional. Sets the KDC server
authentication port to a value in the range 1 to
65535. Default is 88.
•
timeout <1-60> – Modifies KDC server parameters.
•
<1-60> – Defines the time the controller waits for
a response from the KDC Server before retrying.
mobility enable Enables L3 Mobility on WLAN(s).
client-client-disallow Disallows frames from one wireless client to another wireless
client on this WLAN.
nac-mode
[bypass-nac-except-include-l
ist|
do-nac-except-exclude-list|n
one] Sets the Network Access Control (NAC) mode configuration
•
bypass-nac-except-include-list – No Client NAC check is done
except for those in include list. Devices in the include list
have NAC checks.
•
do-nac-except-exclude-list – A Client NAC check is done
except for those in the exclude list. Devices in the exclude list
will not have any NAC checks.
•
none – NAC disabled, no NAC is done. An Client can only get
authenticated by a Radius server.