Brocade Communications Systems RFS6000 - Manual (Page 256)

254 Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Global Configuration commands
5
Parameters
ip access-list extended
[<100-199|<2000-2699>|
]
ip access-list standard
[<1-99>|<1300-1999>|cl-name>] Using the access list parameter options to enter the
ext-nacl context and the std-nacl context. The prompt
changes to the context entered.
•
For more information on extended ACL, see
Chapter 14, Extended ACL Instance
•
For more information on standard ACL, see
Chapter 15, Standard ACL Instance
default-gateway Configures the IP address of the default gateway
•
– IP address of the next-hop router
ip dhcp [bootp|class|
excluded-address|option|
ping|pool] DHCP server configuration.
•
bootp ignore – Defines the BOOTP specific configuration
•
ignore – Configures the DHCP server to ignore BOOTP
requests
•
class – Defines a DHCP class and enters the
DHCP class configuration mode
•
– The DHCP class name
•
excluded-address {} –
Prevents the DHCP server from assigning certain addresses
•
– For IP range, the lower IP number.
Enter this value for a single IP address
•
– Optional. For IP range, the higher IP
number
•
option [ascii|ip] – Defines the
DHCP server’s option name
•
– Defines the name of the option
•
– Defines option code, a value in the
range of 0 to 254
•
ascii – Specify the option type as ascii
•
ip – Specify the option type as ip
•
ping timeout <1-10> – Specifies DHCP server’s ping timeout
in seconds
•
pool – Configures the DHCP server’s address
pool . This opens the
(config-dhcp) instance. For more information, see
Chapter 17, DHCP Server Instance
domain-lookup Enables the DNS based name to address translation on the
controller.
domain-name
Sets the domain name for the controller.
•
– The domain name string
http [secure-server|
secure-trustpoint|
server] Hyper Text Transfer Protocol (HTTP) configuration.
•
secure-server – Sets the device to start the Secure HTTP
Server (HTTPS)
•
secure-trustpoint – Sets the name of the
trustpoint used for secure connection to
•
server – Sets device to start the HTTP server