Brocade Communications Systems RFS6000 User Manual
Page 57
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
55
53-1001931-01
Common commands
2
Syntax (Global Config Mode) (Global Config)
service
[advanced-vty|dhcp|diag|password-encryption|pm|
prompt|radius|redundancy|set|show|terminal-length|
watchdog]
service [advanced-vty|dhcp|watchdog]
service diag
[enable|limit|period|tech-support-period|
tech-support-url]
service password-encryption
secret 2
service pm sys-restart
service prompt crash-info
service radius
{restart}
service redundancy dynamic-ap-load-balance start
service set [command-history|reboot-history|upgrade-history]
<10-100>
service show cli
service terminal-length <0-512>
•
enhanced-probe-table [enable|erase-report|max-client|
preferred|window-time] – Enhanced probe table for Client
locationing.
•
enable – Enables the Enhanced Probe Table feature for
Client locationing.
•
erase-report – Erases the reports for Enhanced Probe
Table feature.
•
max-client <0-512> – Sets the maximum clients in the
Enhance Probe Table report.
•
preferred
preferred Client list.
•
window-time – Sets the Window Time for probe
collection in seconds to a value in the range 10 to 60
seconds.
•
free-packet-watermark – It is free packets threshold. If the
percentage of free packets is lower than this number, then
additional packets will not be queued up in the datapath
•
idle-radio-send-multicast – Forward multicast packets to
radios without associated wireless clients
•
legacy-load-balance – Invoke legacy load balance algorithm
•
map-radios – Set radio-to-cpu mapping constant
•
radio-misc-cfg – radio specific misc configuration U16 for all
radios
•
rate-scale – Enable wireless rate scaling (default)
•
request-ap-log – Request ap Log
•
save-ap-log – Saves debug/error logs sent by the
access-point
•
snmp-trap-throttle – Limits the number of SNMP traps
generated from the wireless module
•
sync-radio-entries – sync radio configuration at cluster levels
•
vlan-cache – VLAN-cache mode