Brocade Communications Systems RFS6000 - Manual (Page 781)

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 779
53-1001931-01
smart-rf config commands
25
radio [<1-4096>|MAC
Address|RADIO|
all-11a|all-11b|all-11bg]
(contd....)
•
all-11a - for all 802.11a radios, the following values are
negated or reset:
•
antenna-gain – Resets the set antenna gain
value.
•
coverage-rate
[1|2|5p5|6|9|11|12|18|24|36|48|54)]- Resets
the selected coverage rate value.
•
lock-auto-assign [all | channel | detector | power |
rescuer] - Resets the lock auto assign value.
•
all-11b - for all 802.11b radios, the following values are
negated or reset:
•
antenna-gain – Resets the set antenna gain
value.
•
coverage-rate
[1|2|5p5|6|9|11|12|18|24|36|48|54] – Resets
the selected coverage rate value.
•
lock-auto-assign [all | channel | detector | power |
rescuer] – Resets the lock auto assign value.
•
all-11bg - for all 802.11bg radios, the following values are
negated or reset:
•
antenna-gain – Resets the set antenna gain
value.
•
coverage-rate
[1|2|5p5|6|9|11|12|18|24|36|48|54] – Resets
the selected coverage rate value.
•
lock-auto-assign [all | channel | detector | power |
rescuer] – Resets the lock auto assign value.
recover [coverage-hole|
interference|neighbor]
enable Negates recover commands.
•
coverage-hole enable – Negates the command to recover
from coverage-hole.
•
interference enable – Negates the command to recover from
interference.
•
neighbor enable – Negates the command to recover from
faulty neighbor radio condition.
retry-threshold
[<0.0-15.0>] Resets recovery-threshold values to default.
scan-dwell-time <1-10> Resets the time a scan dwells on a channel during scan.
schedule-calibrate
[enable|interval|
start-time] Resets the calibration schedule parameters.
•
enable – Disables the calibration schedule feature.
•
interval – Negates the calibration schedule interval.
•
start-time – Negates the calibration schedule start time.
service smart-rf
[max-history|replay
(enable)|rescue] Resets the Smart RF related service commands.
•
smart-rf max-history – Resets the maximum number history
entries.
•
replay enable – Disables the replay mode.
•
rescue – Removes rescue operation
•
WORD – A single radio MAC address
select-channels Revert selected- channels to default
•
WORD– A comma-separated list of channels
smart-rf-module enable Disables the feature
verbose enable Disables the verbose mode of recording every assignment.