Brocade Communications Systems RFS6000 - Manual (Page 260)

258 Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Global Configuration commands
5
• dhcpclass – DHCP User Class instance. For more information, see
Chapter 18, DHCP Class Instance
• Clear the IP DHCP Binding using the clear command
NOTE
To delete Standard/Extended and MAC ACL use
no access-list
under
the Global Config mode.
Usage Guidelines
To create a DHCP User Class:
Create a DHCP class
Create a USER class named MC800 . The privilege mode changes to (config-dhcpclass) .
RFController(config)#ip dhcp class RFControllerDHCPclass
RFController(config-dhcpclass)#
3. Create a Pool named
WID
, using
(config)#
mode
RFController(config)#ip dhcp pool WID
RFController(config-dhcp)#
4. Associate the DHCP class, created in Step 1 with the pool created in Step 3. The controller
supports the association of only 8 CDHCP classes with a pool.
RFController(config-dhcp)#class RFControllerDHCPclass
RFController(config-dhcp-class)#
5. The controller leads you to a new mode (config-dhcp-class). Use this mode to add an address
range used with the DHCP class associated with the pool.
RFController(config-dhcp-class)#address range 11.22.33.44
Example
RFController(config)#ip access-list extended TestACL
RFController(config-ext-nacl)#
RFController(config)#ip access-list standard TestStdACL
RFController(config-std-nacl)#
RFController(config)#ip dhcp pool TestPool
RFController(config-dhcp)#
RFController(config)#ip dhcp class TestDHCPclass
RFController(config-dhcpclass)#