Brocade Communications Systems RFS6000 - Manual (Page 605)

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 603
53-1001931-01
Wireless configuration commands
20
ap-detection
Wireless configuration commands
Configures access point detection parameters
Supported in the following platforms:
• Mobility RFS4000 Controller
• Mobility RFS6000 Controller
• Mobility RFS7000 Controller
Syntax
ap-detection [add|detect-wired-rouge|enable| mu-assisted-scan|timeout]
ap-detection add [authorized|ignored] [|any] |any]
ap-detection detect-wired-rouge enable
ap-detection enable
ap-detection mu-assisted-scan [enable|refresh ]
ap-detection timeout [authorized|unauthorized|ignored]
Parameters
Example
RFController(config-wireless)#ap-detection enable
RFController(config-wireless)#
RFController(config-wireless)#ap-detection authorized add 150 any any
RFController(config-wireless)#
RFController(config-wireless)#ap-detection client-assisted-scan enable
RFController(config-wireless)#
RFController(config-wireless)#ap-detection client-assisted-scan refresh 520
RFController(config-wireless)#
approved add
[|any] Sets the approved access point list
•
add – Adds an entry to the approved access
point list at the index .
•
– The a MAC address in AA-BB-CC-DD-EE-FF
format.
•
any– Assigns any MAC address.
enable Allows access points to look for APs
client-assisted-scan
[enable|
refresh ] Sets wireless client assisted scanning configuration
•
enable – Enables wireless client assisted scanning
•
refresh > – Defines the period
(300 – 86400) (in seconds) used by all
scan-capable wireless clients are polled to scan for
neighboring access points.
ap-detection timeout
[approved|unapproved]
Sets the amount of time (in seconds ) an AP remains in the list
after it is no longer seen
•
approved – The timeout in seconds for
approved APs.
•
unapproved – The timeout in seconds
for unapproved APs