Brocade Communications Systems RFS6000 - Manual (Page 466)

464 Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Extended ACL config commands
14
Parameters
permit ip
[|any|ho
st ]
[|any|host
] {log} {rule-precedence
<1-5000>} Use with a permit command to allow IP packets
•
deny – Sets the action type on an ACL
•
IP – Specifies an IP (to match to a protocol)
•
|any|host – The keyword
is the source IP address of the network or host
in dotted decimal format. The is the network mask.
For example, 10.1.1.10/24 indicates the first 24 bits of the
source IP is used for matching.
•
any – any is an abbreviation for a source IP of 0.0.0.0 and
source-mask bits equal to 0
•
host – host is an abbreviation for the exact source
(A.B.C.D format) and source-mask bits equal to 32
•
|any|host – Defines the destination
host IP address or destination network address.
•
log – Generates log messages when the packet coming from
the interface matches an ACL entry. Log messages are
generated only for router ACLs.
•
rule-precedence <1-5000> – Defines an integer value
between 1-5000. This value sets the rule precedence in the
ACL.
permit icmp
[|any|ho
st ]
[|any|
host ] {
{}} {log}
{rule-precedence
<1-5000>]} Use with the permit command to allow ICMP packets
•
deny – Rejects ICMP packets
•
icmp – Specifies ICMP as the protocol
•
[|any|host ] – The source
is the source IP address of the network or host
(in dotted decimal format). The is the network mask.
For example, 10.1.1.10/24 indicates the first 24 bits of the
source IP is used for matching.
•
any – any is an abbreviation for a source IP of 0.0.0.0 and
source-mask bits equal to 0
•
host – host is an abbreviation for exact source (A.B.C.D) and
source-mask bits equal to 32
•
[|any|host ] – Defines the destination
host IP address or destination network address
•
{} – Sets the ICMP type value
from 0 to 255, and is valid only for ICMP. The
ICMP code value is from 0 to 255, and is valid
only for protocol type icmp.
•
log – Generates log messages when the packet coming from
the interface matches the ACL entry. Log messages are
generated only for router ACLs.
•
rule-precedence <1-5000> – Defines an integer value
between 1-5000. This value sets the rule precedence in the
ACL.