Brocade Communications Systems RFS6000 - Manual (Page 790)

788 Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
smart-rf config commands
25
scan-dwell-time
smart-rf config commands
Sets the time in seconds to dwell on a channel during a channel scan
Supported in the following platforms:
• Mobility RFS4000 Controller
• Mobility RFS6000 Controller
• Mobility RFS7000 Controller
Syntax
scan-dwell-time <1-10>
Parameters
Example
RFController(config-wireless-smart-rf)#scan-dwell-time 10
RFController(config-wireless-smart-rf)#
scan-dwell-time <1-10> The duration in seconds to dwell on a channel during a channel
scan. The default scan dwell time value is 1 second. If the scan
dwell time is increased, the same time will be required to scan
each channel which increases the total calibration time thus
causing the disruption of service during that time.