Brocade Communications Systems RFS6000 - Manual (Page 691)

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 689
53-1001931-01
Wireless configuration commands
20
NOTE: The full syntax for the internal page definition is as follows:
•
wlan 1 hotspot webpage internal
welcome title Welcome to hotspot page.
You have logged on successfully
failure –
Users are redirected to this Web page if they fail
authentication. File must be named fail.html.
•
login – Users are prompted for their username and
password within this Web page. File must be named
login.html.
•
welcome – Users are redirected to this Web page after
they authenticate successfully. File must be named
welcome.html.
•
webpage-location [advanced|external|internal] – The
location of the Web pages used for authentication. These
pages can either be hosted on the controller or an external
Web Server.
•
advanced – Invokes login/welcome/failure Web pages
created by the user on the controller.
•
external – Invokes login/welcome/failure Web pages on
an external server.
•
internal (logout-on-browser-close)– Invokes
login/welcome/failure Web pages created
automatically on the controller.
•
logout-on-browser-close – Enables/disables user
logout on browser close. Default value
disable.
ip [arp|dhcp] Sets Internet Protocol settings for ARP and DHCP packets.
•
arp [rate-limit <1-1000000>|trust] – Address Resolution
Protocol configuration.
•
dhcp trust – Dynamic Host Resolution Protocol
configuration.
•
trust – Sets the arp/dhcp responses as trusted for this
wlan/range.
•
rate-limit <1-1000000> – Does packet rate limiting on ARP
packets to a value in the range 1 and 1000000.
inactivity-timeout
<60-86400> Sets an inactivity timeout in seconds. If a frame is not received
from a wireless client for this amount of time, the wireless client is
disassociated.
independent Sets this WLAN to be an independent WLAN.