Brocade Communications Systems RFS6000 - Manual (Page 381)

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 379
53-1001931-01
Crypto Map config commands
10
service
Crypto Map config commands
Invokes service commands to troubleshoot or debug the
(config-crypto-peer)
instance
configuration
Supported in the following platforms:
• Mobility RFS4000 Controller
• Mobility RFS6000 Controller
• Mobility RFS7000 Controller
Syntax
service show cli
Parameters
Example
RFController(config-crypto-map)#service show cli
Crypto Map Config mode:
+-clrscr [clrscr]
+-do
+-LINE [do LINE]
+-end [end]
+-exit [exit]
+-help [help]
+-match
+-address
+-WORD [match address WORD]
+-no
+-match
+-address
+-WORD [no match address WORD]
+-set
+-localid [no set localid]
+-mode [no set mode]
+-peer
+-A.B.C.D [no set peer (A.B.C.D |WORD)]
+-WORD [no set peer (A.B.C.D |WORD)]
+-pfs [no set pfs]
+-remote-type [no set remote-type]
+-security-association
+-level
+-perhost [no set security-association level perhost]
+-lifetime [no set security-association lifetime]
+-session-key
+-inbound
+-ah [no set session-key ( inbound | outbound ) ah]
+-esp [no set session-key ( inbound | outbound ) esp]
.............................................................................
.............................................................................
...............................................
RFController(config-crypto-map)#
cli Displays the CLI tree of the current mode