Brocade Communications Systems RFS6000 - Manual (Page 465)

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 463
53-1001931-01
Extended ACL config commands
14
permit
Extended ACL config commands
Permits specific packets.
NOTE
ACLs do not allow DHCP messages to flow by default. Configure an Access Control Entry (ACE) to
allow DHCP messages to flow through.
RFController(config-ext-nacl)#permit ip xxx.xxx.xxx.xxx/x 192.168.2.0/24
RFController(config-ext-nacl)#permit ip any host xxx.xxx.xxx.xxx
RFController(config-ext-nacl)#
Supported in the following platforms:
• Mobility RFS4000 Controller
• Mobility RFS6000 Controller
• Mobility RFS7000 Controller
Syntax
permit [icmp|ip|tcp|upd|proto]
permit icmp [|any|host ] [|any|host ]
{ {}} {log} {rule-precedence <1-5000>]}
permit ip [|any|host ] [|any|host ]
{log} {rule-precedence <1-5000>}
permit [tcp|udp] [|any|host ] {eq |range
} [] {eq
} {range } {log}
{rule-precedence <1-5000>}
permit proto [<1-254>|WORD|eigrp|gre|igmp|igp|ospf|vrrp]
[|any|host ][|any|host ]
{log} {rule-description|rule-precedence<1-5000>}